Phone
Send Email
whatsapp
Facebook
Youtube
01
GMF/GMS Series High Frequency Pulse Power Supply
Product Feature
● GM series have pulse waveform output function, compared with high frequency switching power supply, it can obtain higher density deposit layer in electroplating process.
● In the electroplating system where additives are not allowed or a small amount of additives are allowed, a fine, flat and smooth coating can be obtained by high-frequency pulse power supply electroplating.
● Fully digital control system equipped with high-precision sensors to ensure the accuracy of current and power.
● Advanced digital intelligent management system can monitor the power output in real time.
GM series of power supplies can be widely used in hardware electroplating, automobile plate, bathroom treatment, industrial equipment, aluminum foil, consumer electronics and other industries.
Technical Principle
With the increasing complexity, thickness and path density of PCB board, as well as the decreasing aperture and path width, the traditional DC electroplating becomes more and more unsatisfactory, and it is difficult for DC electroplating technology to provide high-speed electroplating and even electroplating distribution for these products. This is mainly concentrated in the central part of the hole, that is, in the field of low current density, which leads to more copper distribution in the edge part of the hole than in the central part of the hole. The positive and negative pulse power supply regulates the aggregation and distribution of copper ions in high and low current densities through the action of pulses.
Electrical parameter
| Output current | 0~8000A |
| Output voltage | 0~100V |
| Pulse frequency | 100Hz |
| Max break make ratio | 500:1 |
| Soft start time | 0 s~2/h |
| Output precision | ±1% |
| Stable voltage waveform | DC, multi-section curve control, single pulse, DC superposition pulse, double pulse, positive and negative pulse cluster. |